Please read instructions thoroughly and completely before beginning installation. Following is steps for installation of ReadyLift (Part#66-1080) Torsion Key that can be applied to Dodge Durango 2WD/4WD and Chrysler Aspen 2WD/4WD. Be carefully when installing this part since the installation requires trained mechanic (recommended).

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height so that you have a base line measurement. Measure fro m
the bottom of the wheel to the lip of the fender, as in Insert A. Position vehicle on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use a floor jack and jack stands or a (2) two post lift if available. Next, locate the torsion key at the rear of the torsion bar under the cab of the vehicle. (Insert B)  Read more...

Lighting. Round fog lamps integral with front fascia. Automatic headlamps (ON/OFF) actuates when ambient light is at low levels, includes headlamps-on-with-wipers. Halogen headlamps. High intensity discharge (HID) low-beam headlamps includes automatic headlamp leveling system and halogen high beams. SmartBeam auto-dimming high-beam headlamp control system (packaged in Entry Nav/Commuter Group on Crew and included in CrewLux)

Mirrors. Power, manual foldaway with heating element, body color. Power folding multifunction with memory, heating element, auto-dimming on driver side, supplemental turn signal and blind spot indicator (if equipped), w/chrome mirrors on CrewLux and Citadel (Packaged in leather interior group on R/T)  Read more...

The Poweraid Throttle Body Spacer which part number 300-631 can be installed for Dodge Ram (2009-2011), Chrysler Aspen 2009 and Dodge Durango 2009 as well. Please read the instruction manual carefully before proceeding the installation and make sure the spare part is completed or not damage during shipping.

Following is steps to install the Poweraid Throttle Body Spacer:

1. Disconnect the negative battery cable! Disconnect the air intake temperature sensor wiring harness by sliding the red tab, and then squeezing the black tab. Loosen two hose clamps, one on each end of the flexible air intake tube. Remove the tube from the vehicle. Lift straight up on the front of engine beauty cover, pull it towards you, and set it aside.  Read more...